ASWP15 Clearing Saw Operation
All brush shall be monitored for falling direction
Safe Limits of Approach shall be followed
Brush greater than 10 cm (4 inches) DBH should not be cut with a clearing saw
Ensure manufacturers' instructions are readily available and have been understood by
the operator
5.0 Work Practice
The following information will provide general information that is required when working with a
clearing saw to remove brush.
Note: Refer to owner / operator manuals for specific clearing saw operation / maintenance.
5.1 Site Inspection
Step Action
Inspect equipment
Inspect for:
Cracks
Sharp blade
Set of blade is appropriate
Adjust clearing saw harness • Adjust harness for saw so that the saw
blade will not contact the feet of the
operator
Inspect Personal Protective Equipment
(PPE)
All PPE must be worn including:
Hardhat
Hearing protection
Eye protection
Foot protection.
Inspect work site
Inspect for and set appropriate barriers for all
hazards and obstacles including but not
limited to:
Electrical conductors
Terrain
Brush height
Brush size
Page 132
